September 27, 2024

100% Updated VMware 3V0-42.20 Enterprise PDF Dumps [Q31-Q51]

Rate this post

100% Updated VMware 3V0-42.20 Enterprise PDF Dumps

Use Valid Exam 3V0-42.20 by PrepAwayPDF Books For Free Website

Understanding functional and technical aspects of Advanced Design VMware NSX-T Data Center 3.0 Products and Solutions

The following will be discussed in VMWARE 3V0-42.20 exam dumps:

  • Troubleshooting and repairing – there are no testable objectives for this section
  • Create a physical design for nsx-t data center
  • Performance-tuning, optimization, upgrades – there are no testable objectives for this section
  • Create a physical design for nsx-t data center networking
  • Create a physical design for nsx-t data center storage

Salary of Advanced Design VMware NSX-T Data Center 3.0 certified professionals

The salary of Advanced Design VMware NSX-T Data Center 3.0 certified professionals varies from $75K to $120K depending on the years of experience.

 

NO.31 Which NSX-T feature is used to allocate the network bandwidth to business-critical applications and to resolve situations where several types of traffic compete for common resources? (Choose the best answer.)

 
 
 
 

NO.32 Which selection is associated with the Review Task of the Engagement Lifecycle? (Choose the best answer.)

 
 
 
 

NO.33 Which three choices are part of a Design Approach when discussing design alternatives and their effects?
(Choose three.)

 
 
 
 
 
 

NO.34 An architect is helping an organization with the Physical Design of an NSX-T Data Center solution.
This information was gathered during a workshop:
Some workloads should be moved to a Cloud Provider.
Extend network’s VLAN or VNI across sites on the same broadcast domain.
Enable VM mobility use cases such as migration and disaster recovery without IP address changes.
Support 1500 byte MTU between sites.
Which selection should the architect include in their design? (Choose the best answer.)

 
 
 
 

NO.35 Which two protocols are typically used for multicast in a NSX-T Data Center environment? (Choose two.)

 
 
 
 
 

NO.36 An NSX-T architect is working with a customer who wants to improve performance and future-proof their workloads with a multi-site architecture.
A current-state analysis captured this information:
Latency between sites is 160ms.
Bandwidth is 2Gbps.
The MTU is 1600.
What two VMware design recommendations should the architect recommend to the organization to achieve future-proofing? (Choose two.)

 
 
 
 
 

NO.37 An architect is helping an organization with the Conceptual Design of an NSX-T Data Center solution.
Which three selections are requirements documented by an architect? (Choose three.)

 
 
 
 
 
 

NO.38 An architect is helping an organization with the Physical Design of an NSX-T Data Center solution.
This information was gathered during a workshop:
Migrating existing data center to KVM hosts.
Redundancy and high availability are required.
No component can be a single point of failure.
Which selection should the architect recommend? (Choose the best answer.)

 
 
 
 

NO.39 An architect is helping an organization with the Logical Design of an NSX-T Data Center solution.
This information was gathered during the Assessment Phase:
Customer is concerned with NSX Manager availability.
3 cabinets/racks are available in the data center.
No integration with 3rd party solution is required.
There is no budget for physical equipment acquisition.
The 3 cabinets/racks do not share the same L2 domain.
Which three selections should the architect include in their design to address the customer’s concern with NSX Manager availability? (Choose three.)

 
 
 
 
 
 

NO.40 An architect is helping an organization with the Conceptual Design of an NSX-T Data Center solution.
This information was gathered by the architect during the Discover Task of the Engagement Lifecycle:
Existing hardware will be used in any design proposal.
Network bandwidth cannot be expanded.
Which concept of the Discover Task do these items belong to? (Choose the best answer.)

 
 
 
 

NO.41 An architect is helping an organization with the Logical Design of an NSX-T Data Center solution.
This information was gathered during the Assessment Phase:
* Maximum performance and availability is required between the physical and virtual network.
* Load Balancing service is required for back-end web servers.
* NAT is required.
Which selection should the architect include in their design? (Choose the best answer.)

 
 
 
 

NO.42 Which three IPv6 features are supported in an NSX-T Data Center design? (Choose three.)

 
 
 
 
 
 

NO.43 An architect is helping an organization with the Physical Design of an NSX-T Data Center solution.
This information was gathered during a workshop about ESXi Host networking:
* A total of 50 ESXi hosts to be configured as Transport Nodes.
* All ESXi hosts have a dedicated 2 × Intel 10Gbps Physical Network adapter for the Overlay Traffic.
To achieve low latency, high throughput, redundancy, and performance, which two NIC teaming policies should the architect recommend? (Choose two.)

 
 
 
 
 

NO.44 A Solutions Architect is designing an environment with 1,200 services being offered through the NSX-T Data Center Load Balancer.
Which three selections are necessary to meet the minimum requirements to support the solution? (Choose three.)

 
 
 
 
 
 

NO.45 Which selection must be taken into consideration when creating a Logical Design for a planned migration?
(Choose the best answer.)

 
 
 
 

NO.46 Which two resources can be used by an NSX architect during the Assessment Phase? (Choose two.)

 
 
 
 
 

NO.47 A customer deploying NSX-T Data Center requires role based access controls be enforced in NSX Manager with these requirements:
identity platform must be highly available
authentication must be performed by customer’s existing SAML identity provider MFA must be performed by administrator to gain access to NSX Manager Which identity deployments would meet the customer’s requirements? (Choose the best answer.)

 
 
 
 

NO.48 Which three choices are non-functional requirements? (Choose three.)

 
 
 
 
 
 

NO.49 A customer deploying NSX-T Data Center requires role based access controls be enforced in NSX Manager with these requirements:
* identity platform must be highly available
* authentication must be performed by customer’s existing SAML identity provider
* MFA must be performed by administrator to gain access to NSX Manager
Which identity deployments would meet the customer’s requirements? (Choose the best answer.)

 
 
 
 

NO.50 A customer has a requirement to implement a next generation firewall (NGFW) to improve security network introspection. The customer wants to apply the NGFW to all workloads exposed both internally and externally. The customer wants the NGFW to work seamlessly with NSX-T Data Center and vSphere.
Which solution should be recommended to the customer? (Choose the best answer.)

 
 
 
 

NO.51 An architect is helping an organization with the Physical Design of an NSX-T Data Center solution.
This information was gathered during a workshop:
* Current hypervisor of choice is KVM.
* Cost reduction is important.
Which two selections should the architect recommend to the organization? (Choose two.)

 
 
 
 
 

What is the cost of Advanced Design VMware NSX-T Data Center 3.0

The cost of Advanced Design VMware NSX-T Data Center 3.0 is $450.

  • Format: Multiple choices, multiple answers
  • Length of Examination: 105 minutes
  • Passing Score: 300
  • Number of Questions: 57

 

VMware 3V0-42.20 Official Cert Guide PDF: https://www.prepawaypdf.com/VMware/3V0-42.20-practice-exam-dumps.html

Leave a Reply

Your email address will not be published. Required fields are marked *

Enter the text from the image below