[Q19-Q38] Latest GB0-381-ENU Exam with Accurate H3C Large-Scale Routing Network Technologies V2.0 PDF Questions [Apr 24, 2022]

NEW QUESTION 19
In the following NSAP, the NET address that can be used as an integrated IS-IS is _______.

NEW QUESTION 20
L is a network design engineer. In a certain network project, in order to reduce the complexity, the small L design network adopts a two-layer architecture, and the access layer functions are incorporated into the convergence layer. In the design, the small L takes into account that the core layer needs to have a fast convergence function, and the convergence layer performs route aggregation to reduce the number of routes. Among the following routing protocols, which one should be used by Little L as the core layer routing protocol? (Choose one or more)

NEW QUESTION 21
In the topology shown in the figure, perform the following configuration in RTA and RTB respectively:
RTA-ospf-1-area-0.0.0.1]network 192.168.0.0 0.0.0.255
RTA-ospf-1-area-0.0.0.1]network 192.168.1.0 0.0.0.255
RTA-ospf-1-area-0.0.0.1]network 192.168.2.0 0.0.0.255
RTA-ospf-1-area-0.0.0.1]network 192.168.3.0 0.0.0.255
RTA-ospf-1-area-0.0.0.1]network 192.168.4.0 0.0.0.255
RTB] acl number 2000
RTB-acl-basic-2000] rule 0 permit source 192.168.0.0 0.0.0.255
RTB-acl-basic-2000] rule 5 permit source 192.168.1.0 0.0.0.255
RTB-ospf-1] filter-polic2000 import
Then the possible routes in the RTB routing table are _____

NEW QUESTION 22
In the OSPF protocol, when the interface network type is P2P (point-to-point), the default Hello time interval and neighbor failure time are respectively ______.

NEW QUESTION 23
In the network shown in the figure, the BGP routing learning between the routers is normal, and the BGP routing attributes all take default values.
After the route 8.0.0.0 is imported into BGP on RTA, if the next hop of route 8.0.0.0 on RTD is to point to RTB, the following adjustment methods are feasible again.

NEW QUESTION 24
Regarding filter-polic filtering OSPF routes, which of the following statements are correct?

NEW QUESTION 25
About the difference between system policy routing and interface policy routing. The correct statement is _________

NEW QUESTION 26
Perform the following configurations on RTA, RTB, and RTC in the topology shown in the figure:
RTA-GigabitEthernet0/0] ip address 192.168.2.1 255.255.255.0
RTA] ospf 1 router-id 1.1.1.1
RTA-ospf-1] area 1
RTA-ospf-1-area-0.0.0.1] network 192.168.2.0 0.0.0.255
RTB-GigabitEthernet0/0] ip address 192.168.2.2 255.255.255.0
RTB-GigabitEthernet0/1] ip address 192.168.3.1 255.255.255.0
RTB] ospf 1 router-id 2.2.2.2
RTB-ospf-1] area 1
RTB-ospf-1-area-0.0.0.1] network 192.168.2.0 0.0.0.255
RTB-ospf-1] area 0
RTB-ospf-1-area-0.0.0.0] network 192.168.3.0 0.0.0.255
RTB-ospf-1]import-route direct
RTC-GigabitEthernet0/0] ip address 192.168.3.2 255.255.255.0
RTC] ospf 1 router-id 3.3.3.3
RTC-ospf-1] area 0
RTC-ospf-1-area-0.0.0.0] network 192.168.3.0 0.0.0.255
Then the types of LSAs generated by RTB in the OSPF area are _______

NEW QUESTION 27
Regarding the filter-polic filter, which of the following statements is incorrect?

NEW QUESTION 28
L is a network design engineer. In a certain network project, in order to reduce the complexity, the small L design network adopts a two-layer architecture, and the access layer functions are incorporated into the convergence layer. In the design, the small L takes into account that the core layer needs to have a fast convergence function, and the convergence layer performs route aggregation to reduce the number of routes. Among the following routing protocols, which should be used by L as the aggregation layer routing protocol? (Choose two)

NEW QUESTION 29
Among the following statements about BGP load sharing, the correct one is ______.

NEW QUESTION 30
A router has an interface that uses frame relay to connect to multiple routers, and now IS-IS needs to be run between these routers, what needs to be done on this interface?

NEW QUESTION 31
Which of the following commands is used to reset PBR statistics?

NEW QUESTION 32
In the network shown in the figure, the default next hop of RTA is RTC, and the PBR configuration is as follows:
polic-based-route pbr_a permit node 10
if-match acl 3000
appldefault output-interface serial 2/0
polic-based-route pbr_a dennode 20
According to the above configuration, how will the data stream matching Acl 3000 on RTA be forwarded?

NEW QUESTION 33
Configure the silent interface on the router so that the router does not send OSPF protocol messages. The command is _______.

NEW QUESTION 34
Regarding the import-route command, which of the following statements are correct?

NEW QUESTION 35
There are 4 routes 10.0.0.0/24, 10.0.1.0/24, 10.0.2.0/24, and 10.0.3.0/24 in the routing table.
For route aggregation, the correct route after aggregation is _________.

NEW QUESTION 36
Each OSI network device is networked as shown in the figure. There are ______ ESs in the OSI network. (Host)

NEW QUESTION 37
The following belong to the core layer function is _______. (Choose one or more)

NEW QUESTION 38
Regarding the comparison between OSPF and RIP, which of the following statements are correct?