Guaranteed Success in CCNP Service Provider 300-515 Exam Dumps [Q28-Q47]

NO.28

Refer to the exhibit. Which statement describes the result of this configuration?

NO.29 Which utility can you use to validate an LSP in an MPLS environment?

NO.30 While configuring the VRF Selection feature, you get an error message after typing the below statement:
Router(config)#no vrf selection source 172.16.0.0 255.255.0.0 vrf VRF1
Which action caused this message?

NO.31 Which two are characteristics of using a non-MPLS peer-to-peer model over a traditional overlay model? (Choose two.)

NO.32 Which two BGP attributes prevent loops in a route reflector environment? (Choose two.)

NO.33 A network engineer is implementing Layer 3 MPLS VPNs on Cisco IOS/IOS XE PE routers. Which PE-to- CE routing protocol requires a separate routing process to be created for each VRF?

NO.34 Refer to the exhibit.

Which result occurs when PE1 learns a new MAC address and all three PEs are enabled with EVPN native?

NO.35 Refer to the exhibit.

PE1 and PE2 are exchanging VPNv4 routes for CE1 and CE2, and PE3 contains the default route to the internet. If the three devices are operating normally, which two conclusions describe this configuration?
(Choose two.)

NO.36 An engineer needs to improve MPLS network management by implementing a set of tools to support the NOC engineers in troubleshooting network failures. Which feature should the engineer implement to check the connectivity of the MPLS LSP between the ingress and egress PE routers?

NO.37 Refer to the exhibit.

An organization is running H-VPLS on a network comprising four routers in a hub-and-spoke topology with R1 as the hub An engineer added a new spoke with multiple VCs to the network, and now traffic cannot flow properly How should the engineer update the configuration on R1 to correct the problem?

NO.38 Refer to the exhibit:

A network engineer is implementing an OSPF configuration Based on the output, which statement is true?

NO.39 Which mechanism reduces the network flooding caused by host ARP learning behavior?

NO.40 Refer to the exhibit.

Which statement about this output is true?

NO.41 While configuring the VRF Selection feature, you get an error message after typing the below statement:
Router(config)#no vrf selection source 172.16.0.0 255.255.0.0 vrf VRF1
Which action caused this message?

NO.42 What must match in the EVPN and L2VPN configuration mode when configuring EVPN native in a router?

NO.43 You try to configure MPLS VPN VRF Selection based on a source IP address on an interface that has VRF configured, but you receive an error.
Which action must you take to correct the problem?

NO.44 Refer to the exhibit.

A network operator is implementing EVPN IRB on PE1. Which two command placements enable the advertisement of Type 2 routes and what information do Type 2 routes contain? (Choose two.)

NO.45 Which utility can you use to validate an LSP in an MPLS environment?

NO.46 How does Layer 3 VPN traffic traverse an ISP network?

NO.47 Which kind of traffic is supported in an MVPN Extranet?