[Jun 05, 2022] Ultimate NS0-520 Guide to Prepare Free Latest Network Appliance Practice Tests Dumps [Q13-Q28]

NO.13 Exhibit.

The VMware ESX host discovers only two of four paths to a LUN on a new ONTAP cluster.
Referring to the exhibit, which statement Is correct?

NO.14 You have a performance critical database application that is running on a FAS9000 controller that uses FC. As shown in the exhibit, volume efficiency is enabled.
If you follow the performance recommendation, what are two results to the data in the volume? (Choose two.)

NO.15 A customer needs to change ports 0e and 0f on AFF_1 to support FC.
Referring to the exhibit, which three steps are required to accomplish this task? (Choose three.)

NO.16 Which two scenarios in deploying ONTAP Cloud are supported by the Cloud Manager tool? (Choose two.)

NO.17 After the addition of extra DS224C disk shelves, you notice that the output of the system node run -node node_1 sysconfig command shows Mixed-path. You need to investigate why the additional shelves are providing this error.
In this scenario, which two tools would help diagnose this issue? (Choose two.)

NO.18 You are designing a new 4-node AFF A400 SAN cluster with 20 ISCSI hosts. Each AFF A400 node will have four data LIFs. Each ISCSI host needs to access every LUN over two LIFs per node on every SAN node.
In this scenario, which Netapp SAN feature enable this connectivity?

NO.19 An administrator is adding new hosts to a vSphere cluster. The cluster uses the FC protocol to connect to a NetApp cluster. The administrator wants to configure the multipathing for the ESXi host.
Which NetApp tool should be used to accomplish this task?

NO.20 A customer’s NetApp infrastructure is reaching end-of-life (EOL), and they want to inventory their NetApp cluster. The customer wants to make sure that the proposed technical refresh satisfies their growing data demands.
Which two tools would you use to help with this recommendation? (Choose two.)

NO.21 You have a 4-node AFF A400 cluster serving iSCSI and FC LUNs. You are asked to tier Snapshot copy data from the SSDs to both Azure Blob storage and Amazon S3. The two sets of Snapshot copies must be managed by ONTAP software so that they are accessible for cloning and replication.
In this scenario, which NetApp technology accomplishes this task?

NO.22 Referring to the exhibit, which container gains space savings from deduplication, compression and compaction?

NO.23 As a system administrator, you perform a routine check of available storage space on your FAS2750. You notice that the vol_1 volume is approaching 100% capacity. The volume is configured with the space guarantee set to volume and the LUN reservation is disabled. You want to free up space in the volume without increasing its size.
Which action would accomplish this task?

NO.24 You are installing an AFF A250 system with ONTAP 9.8 software. Your customer asks you about the recommended LIF configuration for the ISCSI protocol. In this scenario, which two statements are correct (choose two)

NO.25 You are configuring FC ports on front-end SAN switches for a 4-node Metrocluster configuration across two data centers. You need to ensure that each data center serves FC LUNs when an FC port goes offline in one data center. In this scenario, which front end switch setting must be modified to avoid overlap when a new port comes online?

NO.26 Referring to the exhibit, which WWPN would safely be removed from the zone?

NO.27 You have implemented FabricPool on your AFF ASA ONTAP 9.8 Cluster. An archived database has become very active, and it requires FabricPool adjustments.
Which two steps are required to address this issue? (Choose two)

NO.28 An administrator has an AFF A200 cluster at their primary site that is used for FC connectivity to servers. For disaster recovery purposes they want to start replicating their data to another AFF A3Q0 cluster In a secondary location. The AFF A300 is In a site that has no FC or FCoE capable switches, and is currently only used for CIFS dat a. A cluster peering relationship already exists between the two clusters.
Which three additional actions are needed for the data to be ready for access from hosts at the secondary site? (Choose three.)