[Q31-Q52] Real EMC DEA-5TT1 Exam Questions [Updated 2022]

QUESTION 31
Refer to the exhibit.

Switch A and Switch B are connected to each other. Both switches use interfaces Gi1/0/1 and Gi1/0/2. Switch A has a Spanning Tree priority of 8192 and Switch B has the default priority. Which interface becomes the root port?

QUESTION 32
Which formula is used for calculating OSPF interface costs?

QUESTION 33
What accurately describes the Network Time Protocol (NTP)?

QUESTION 34
What is the bandwidth of an RPM for a C9010 Network Director?

QUESTION 35
Which IEEE standard defines the Data Link Layer, Discovery protocol?

QUESTION 36
Which Dell EMC Networking M-Series 10 GbE switch model supports a VLT?

QUESTION 37
Router A is directly connected to Router B over an Ethernet link. The local interface address for the Router A Fo0/48 interface is 144.254.32.2/24. Which routing table entry is visible on Router A?

QUESTION 38
A VLAN has been configured to have an IPv6 address and a stateless address autoconfiguration for clients. Which IPv6 address prefix will the default gateway have on a client?

QUESTION 39
Refer to the exhibit.

Switch A and Switch B are connected to each other. Both switches use interfaces Gi1/0/1 and Gi1/0/2.
Switch A has a Spanning Tree priority of 8192 and Switch B has the default priority. Which interface becomes the root port?

QUESTION 40
Which route type is added to the routing table by a routing protocol?

QUESTION 41
Which Border Gateway Protocol (BGP) version supports IPv6?

QUESTION 42
The IEEE separates the Data Link and Physical ISO layers into four sub-layers. Based on the exhibit, what is the correct order of these sub-layers; from lowest to highest?

QUESTION 43
Which topology is considered a best practice when stacking switches?

QUESTION 44
What are Network Address Translation (NAT) inside global addresses?

QUESTION 45
What is the default OSPF “hello interval”?

QUESTION 46
What is the Organizationally Unique Identifier (OUI) in the MAC address 00:C4:4F:23:AF:4A?

QUESTION 47
Which Layer 1 device can be used to enlarge the area covered by a single LAN segment?

QUESTION 48
Which platforms are supported by the Dell EMC Networking OS (DNOS) 6?

QUESTION 49
Which component translates data, signaling, and protocols to facilitate the data flow between the end device and the network?

QUESTION 50
A Dell EMC Networking N-Series switch is configured on a port channel with LACP using the interfaces Te1/0/1 and Te1/0/2. How is the egress traffic distributed among the interfaces?

QUESTION 51
If a packet is sent to an IPv6 address and many devices receive the packet, what is this type of traffic?

QUESTION 52
Which Border Gateway Protocol (BGP) version supports IPv6?