NACE-CIP1-001 Premium PDF & Test Engine Files with 100 Questions & Answers [Q38-Q54]

NO.38 The least effective method of surface cleaning is most likely

NO.39 ISO SA 3 is directly equivalent to:

NO.40 Which one of the following documents is the best source for coating technical data:

NO.41 ISO SA 2 is defined as:

NO.42 Removal of welds splatter is required:

NO.43 What is the minimum spot measurement value allowed by SSPC-PA 2 in each 10 m2 (100 ft2) area?

NO.44 NACE SP 0178 is a standard for:

NO.45 Conventional spray is a good choice when:

NO.46 You ate the NACE Inspector on a job where NACE No. 2/SSPC – SP 10 has been specified. You are finding the Contractor is leaving mill scale on the on surface and as a result you have been rejecting the blast. The Contractor is very upset and has told you that the standard permits up to 5% of the mill scale to remain and still be in be in compliance with the standard.
Your FIRST preferred course of action is to:

NO.47 Common errors that may produce inaccurate readings when using a Dial-Type Magnetic Pull-Off Dry Filth Thickness (DFT) gauge include:
Select All That Apply

NO.48 When holiday testing is required the Inspector is always required to enforce NACE SP 0188:

NO.49 If the project specification DOES NOT state the specific DFT measurement standards, the inspector should use

NO.50 The primary difference between Non-Convertible vs. Convertible coatings is:

NO.51 Most industrial coatings are:

NO.52 As a NACE Coating Inspector your responsibility with respect to safety is to:

NO.53 Non Conformance Reports are completed by the Inspector:

NO.54 To be of value the Inspector’s documentation must be: