Updated Apr-2023 Test Engine to Practice NACE-CIP1-001 Dumps & Practice Exam [Q20-Q42]

NEW QUESTION 20
You are the NACE Inspector on a job where ISO ST 3 has been specified. The Contractor normally works to SSPC standards and been referencing SSPC SP 3.
Could this have any impact on the final surface preparation appearance?

NEW QUESTION 21
NACE Level 1 Inspectors have been trained to perform:

NEW QUESTION 22
An Inspector should change position when:

NEW QUESTION 23
Conventional spray is a good choice when:

NEW QUESTION 24
Excess moisture during holiday testing can cause erroneous indications by creating a path across the surface of the coating to pinholes previously detected, or directly to the signal return connection.
This is often referred to as:

NEW QUESTION 25
A single application coating film has a measured dry film thickness (DFT) between 4 and 5 mils (between 100 and 125 microns). The volume solids of the coating immediately before application were 67%, What wet film thickness (WFT) was applied?

NEW QUESTION 26
Stripe coats are best applied by:

NEW QUESTION 27
The Inspector’s Log Book is generally:

NEW QUESTION 28
A magnetic pull-off type gauge is a good choice when:

NEW QUESTION 29
Upon arrival of coating materials, the inspector should

NEW QUESTION 30
You have just received your NACE CIP Level 1 certification when you are asked to supervise a team of uncertified field pipeline inspectors.
Your FIRST preferred course of action is to:

NEW QUESTION 31
The form of corrosion that has the largest potential for unexpected catastrophic failure is:

NEW QUESTION 32
You ate the NACE Inspector on a job where NACE No. 2/SSPC – SP 10 has been specified. You are finding the Contractor is leaving mill scale on the on surface and as a result you have been rejecting the blast. The Contractor is very upset and has told you that the standard permits up to 5% of the mill scale to remain and still be in be in compliance with the standard.
Your FIRST preferred course of action is to:

NEW QUESTION 33
What is the minimum recommended distance away from an edge that an inspector should take a measurement with a dial-type magnetic pull-off Dry Film Thickness (DFT) gauge?

NEW QUESTION 34
Good records can provide maintenance departments with detailed information about ALL of the following EXCEPT

NEW QUESTION 35
Excessive working of the surface with a power grinder can be detrimental because excessive burnishing

NEW QUESTION 36
Which one of the following documents is the best source for coating technical data:

NEW QUESTION 37
On a blast-cleaned surface, Ian ultraviolet light is generally used to detect

NEW QUESTION 38
If the project specification DOES NOT state the specific DFT measurement standards, the inspector should use

NEW QUESTION 39
Digital hygrometers

NEW QUESTION 40
When using the ISO comparator in accordance with ISO 8503, if the surface profile does not directly compare to one of the four segments the inspector should:

NEW QUESTION 41
The Inspector should record the serial numbers of inspection instruments:

NEW QUESTION 42
How many gauge readings does SSPC-PA 2 require within a 4 cm (1.5 inch) diameter circle?