JN0-351 Questions Pass on Your First Attempt Dumps for JNCIS-ENT Certified [Q38-Q54]

QUESTION 38
What are two reasons for creating multiple areas in OSPF? (Choose two.)

QUESTION 39
Which two mechanisms are part of building and maintaining a Layer 2 bridge table? (Choose two.)

QUESTION 40
Which two BGP attributes must be supported by all BGP implementations and must be included in every update? (Choose two.)

QUESTION 41
What is the default keepalive time for BGP?

QUESTION 42
You have two OSPF routers forming an adjacency. R1 has a priority of 32 and a router ID of 192.168.1.2. R2 has a priority of 64 and a router ID of 192.168.1.1. The routers were started at the same time and all other OSPF settings are the default settings.
Which statement is correct in this scenario?

QUESTION 43
Exhibit.

Why is this OSPF adjacency remaining in this state?

QUESTION 44
You deployed a new EX Series switch with DHCP snooping enabled and you do not see any entries in the snooping databases for an interface. Which two Juniper configurations for that interface caused this issue?
(Choose two.)

QUESTION 45
Exhibit.

What is the management IP address of the device shown in the exhibit?

QUESTION 46
Exhibit

Referring to the exhibit, which statement is correct?

QUESTION 47
You are concerned about spoofed MAC addresses on your LAN.
Which two Layer 2 security features should you enable to minimize this concern? (Choose two.)

QUESTION 48
Exhibit.

You want to verify prefix information being sent from 10.36.1.4.
Which two statements are correct about the output shown in the exhibit? (Choose two.)

QUESTION 49
Two routers share the same highest priority and start time.

QUESTION 50
Which statement about aggregate routes is correct?

QUESTION 51
You are attempting to configure the initial two aggregated Ethernet interfaces on a router but there are no aggregated Ethernet interfaces available.
In this scenario, which configuration will enable these interfaces on this router?

QUESTION 52
You are receiving multiple BGP routes from an upstream neighbor and only want to advertise a single summarized prefix to your internal OSPF neighbors. This route should only be advertised when you are receiving these BGP routes from this neighbor.
In this scenario, which type of route should you create?

QUESTION 53
Which two statements correctly describe RSTP port roles? (Choose two.)

QUESTION 54
An update to your organization’s network security requirements document requires management traffic to be isolated in a non-default routing-instance. You want to implement this requirement on your Junos-based devices.
Which two commands enable this behavior? (Choose two.)