Verified H35-480_V3.0 dumps Q&As – 2024 Latest H35-480_V3.0 Download [Q20-Q40]

NO.20 In the inter-site DC solution, the X2 interface can be used to implement transmission interconnection between the LTE and NR sites. Which of the following is the requirement of the transmission delay in such case?

NO.21 At which layer is downlink data split implemented over the NR air interface in the NSA Option 3x architecture?

NO.22 What are the typical sizes of ping packets and intervals in single site verification? (Choose All that Apply)

NO.23 During a 5G service test, an NSA UE connects to the Probe and then accesses a 4G cell. It is found that the cell does not deliver B1 measurement configurations. Which of the following is not a possible cause for this?

NO.24 If the length of the CPRI optical fiber between a BBU and an RRU exceeds 150 m, you are advised to use a multimode fiber.

NO.25 Which of the following RF modules support 64T64R?

NO.26 On an NSA network, the eNodeB immediately triggers the SgNB addition procedure after a UE attaches to the LTE network. If the SgNB addition fails, the eNodeB attempts to add the SgNB again until it is successful.

NO.27 What is the maximum number of PCIs supported by a 5G network?

NO.28 During 5G single site verification, you only need to test the user access and rate. Other test items are analyzed in drive tests.

NO.29 After the cell search is complete, a 5G UE automatically selects a PLMN based on the priority sequence. Which PLMN will the UE preferentially select for registration?

NO.30 Which of the following methods can be used to obtain VLAN IDs after a base station is powered on?

NO.31 Which of the following functions are implemented by the UBBP board in the BBU5900? (Choose all that Apply)

NO.32 According to 5G eMBB service requirements, which of the following is the minimum rate required for network edge coverage?

NO.33 F-OFDM over the NR air interface uses flexible subcarrier spacing to meet the requirements of different 5G service scenarios. Which of the following types of subcarrier spacing is not supported by Sub6G?

NO.34 E2E network device update is required for the evolution from 5G NSA networking to SA networking.

NO.35 Which of the following MML commands is used to bind a physical sector to an AAU on a gNodeB?

NO.36 According to 3GPP specifications, which of the following is not an RRC state in 5G?

NO.37 What is the required distance between a CPE and a gNodeB in a 5G network test?

NO.38 On an NSA network, the eNodeB immediately triggers the SgNB addition procedure after a UE attaches to the LTE network. If the SgNB addition fails, the eNodeB attempts to add the SgNB again until it is successful.

NO.39 Which of the following MML commands can be used to query version information relating to the software stored on the gNodeB?

NO.40 Which of the following frequency locking modes is not supported when the GENEX Probe is used to perform a CPE test?