100% Pass Guaranteed Free HPE7-A07 Exam Dumps Jul 26, 2024 [Q26-Q41]

NO.26 A customer wan a gateway connected to a device on gigabitethernet0/0/3 configures an Asset ID TLVon the device for inventory management.
Exhibit.

The customer mentions me Asset ID is not shown What is causing the issue?

LLDP TX is not enabled.

LLPD-MED needs to be enabled.

MTU size is too small.

Unknown TLVs cannot be displayed.

NO.27 Which statement is true given the following CLIoutput from a CX 6300?

The underlay loopback addresses are in the 172 21 11 x range.

There are two anycast addresses m me overlay fabric.

Duplicate MAC addresses were detected in the overlay fabric

There are three active client overlay VLANs in the overlay fabric

NO.28 Which statements accurately describe OSPF Graceful Restart (when the restarting router is able to Keep its forwarding tables across the restart)? (Select two.)

The GR helper role is supported on AOX-CX 6100 switches.

VSF Failover and Graceful-Restart require a VSF secondary member in the VSF stack

Bidirectional Forwarding Detection for OSPF and GR are mutually exclusive features.

OSPF Routers listen for Grace-LSAs on each network segment where there is an OSFP adjacency.

You must ensure your VSF stack has a secondary member when acting as a GR helper

NO.29 A customer’s infrastructure is set up to use both primary and secondary gateway clusters on the SSID profile based on best practices What is a valid cause tor having an equal spirt in APs connected to the primary and secondary gateway clusters?

The secondary gateway cluster is heterogeneous

The secondary gateway cluster is homogeneous

The primary gateway cluster is up. out some APs are unable to reach the primary gateway cluster. These APs would connect to the secondary gateway cluster

The primary gateway cluster is up. out some APs cannot reach the secondary gateway cluster. These APs would connect to the secondary gateway cluster

NO.30 in a WLAN network with a tunneled SSID. you see the following events in HPE Aruba Networking Central:

The customer asks you to investigate log messages What should you tell them?

This indicates a security issue. The client with a MAC address ending with 37 18;0d Is performing a Denial-of-Service attack on your network. You should track down the client and remove it from the network.

This is normal, expected behavior. No further actions are needed.

This indicates a client WLAN driver issue for the client with a MAC address ending with 37:18
:Od. You should upgrade the client WLAN driver.

There is a roaming issue Enable Fast Roaming 802.11r and OKC to resolve the issue.

NO.31 A customer has deployed an AOS 10 mobility gateway cluster consisting of three controllers at a single site The WLAN is configured to tunnel wireless device traffic to the AOS 10 mobility cluster The clients are authenticated by ClearPass using WPA3-Enterprise (opmode wpa3-aes-ccm-128). The security team has requested the ability to force a wireless device to reauthenticate using ClearPass.
Which steps are required to ensure ClearPass can consistently initiate a change of authorization against an AOS 10 mobility cluster, including during gateway failover scenarios? (Select two)

set cluster mode to Auto Site under High Availability – Cluster configuration

modify WLAN – SSID – VLAN – Mode Configuration

enable manual cluster configuration under High Availability – Cluster Configuration

enable Dynamic Authorization CoA under High Availability – Cluster Configuration

modify NAS IPv4 address under Security – Advanced – RADIUS Client

NO.32 A network technician racked up two 9240 mobility gateways in a single cluster that will be terminating 1700 APs in a medium-sized branch office Next, the technician cabled the gateways with two SFP28 Direct Attach Copper (DAC) cables, distributed between a two-member core switching stack and powered them up.
What must the network administrator do next regarding the gateway configuration to ensure maximum wired bandwidth utilization?

Map two physical ports to a port channel on each gateway.

Make an ports trunk interfaces and permit data VLANs

Disable the spanning tree and allocate unique VLANs to each port.

Manually set 25Gbps speeds on all ports.

NO.33 Exhibit.

Which statement is true?

The SSID supports RC4 encryption.

The SSID supports 802.11nac clients.

The SSID supports implicit beamforming.

The SSID supports sending neighbor reports.

NO.34 You are testing the use of the automated port-access role configuration process using RadSec authentication over VXLAN. During your testing you observed that the RadSec connection will fan during the digital certificate exchange What would be the cause of this Issue?

The RadSec server was defined on the switch using an IPv6 address that was unreachable

Tracking mode was set to “dead-only”, and the RadSec server was marked as unreachable.

The switch is configured to establish a TLS connection with a proxy server, not the radius server.

The RADIUS TCP packets are Being dropped and the TLS tunnel is not established.

NO.35 The ACME company has an AOS-CX 6200 switch stack with an uplink oversubscription ratio of 9.6:1. They are considering adding two more nodes to the stack without adding any additional uplinks due to cabling constraints One oftheir architects has expressed concerns that their critical UDP traffic from both wired and bridged AP clients will encounter packet drops.They have already applied the following configuration:

Which strategy will complement this solution to achieve their objective?

edge mark lower priority TCP traffic with AF12

edge mark critical UDP Traffic with CSS

edge mark lower priority TCP traffic with AF11

edge mark critical UDP traffic with AF42

NO.36 Match each Group Based Policy(GBP) rote description to its respective role ID.

NO.37 Your customer is requesting a4-ciass LAN queuing model tor QoS. Following best practices, match the PHB/DSCP values to the application types.

NO.38 Exhibit.

A network administrator attempts to improve multicast traffic flow and performs some packet captures for validation What can the network administrator conclude from the results?

The data rate increased from 6 Mops to 300 Mops because Broadcast Multicast optimization (BCMCO) was configured.

The capture taken after optimization does not show a packet length because Multicast Transmission Optimization was configured.

The type flew remains consistent because Dynamic Multicast Optimization (DMO) was configured.

The data rate increased from 6 Mbps to 300 Mops because Dynamic Multicast Optimization (DMO) was configured.

NO.39 The ACME company has an AOS-CX 6200 VSF switch slack with an uplink over subscription ratio of 9.6:1.
They have indicated that their low-priority TCP traffic has been flagged with a DSCP marking coloring them yellow.
Refer to the exhibit.

They are considering adding two more nodes to thestack without adding any additional uplinks due to existing wiring constraints.One of their architects has suggested adding the following configuration:

What would be the impact of applying the acmethreshold profile as shown? (Select two.)

All upper-layer protocol traffic egressing LAG1 will be subject to drop probability.

All TCP traffic egressing LAG1 wail be subject to drop probability

Only VoIP packets egressing queue 5 on LAG1 will likely be protected from uplink over-utilization.

VoIP packets egressing any queue on LAG1 will more likely be protected from uplink over-utilization

Yellow-flagged TCP traffic egressing LAG1 will be subject to drop probability

NO.40 A customer would like to allow their IT Helpdesk to configure loT devices to connect lo a single SSID using a unique PSK that other devices cannot use. Which solution would you recommend?

MPSK AES with MAC Auth

MPSK Local

MPSK AES with Cloud Auth

MPSK AES with ClearPass

NO.41 An OSPF router has learned a pain 10 an external network by Doth an E1 and an E2 advertisement Both routes have the same path cost Which path will the router prefer?

The router will prefer the E1 path.

The router will use Doth paths equally utilizing ECMP.

The router will prefer the E2 path.

Both routes will be suppressed until the path conflict has been resolved.

Related posts:

admin

You might also like

Leave a Reply Cancel reply