[2025] Practice with these Senior-Internal-Corrosion-Technologist dumps Certification Sample Questions [Q49-Q69]

QUESTION 49
You ate the NACE Level 2 Coating Inspector where SSPC PA 2 has been specified with an additional requirement that no Individual gauge reading shall be below a certain value. As this is not part of the standard you should:

QUESTION 50
A reinforced coating is

QUESTION 51
Coating surveys may Include which steps? Select All That Apply:

QUESTION 52
Application of Thermal Spray Coatings requires:

QUESTION 53
Coating application to concrete substrates is:

QUESTION 54
NACE International Standards are developed by:

QUESTION 55
A failure caused by applying a coating too thinly is known as

QUESTION 56
Eddy current DFT gauges are used to measure Dry Film Thickness in which of the following situations:

QUESTION 57
When performing Inspection in accordance with ASTM D 4138 the Inspector will use:

QUESTION 58
The primary purpose of Fireproofing coatings are to provide:

QUESTION 59
When environmental enclosures ate being used an inspector needs to be concerned about:

QUESTION 60
Which standards are generally established by private-sector bodies and are available for use by any person or organization, private or government?

QUESTION 61
You are the NACE Level 2 Inspector on a project where overcoating of galvanized steel is being performed.
The specification references SSPC SP 16 as the surface preparation method. At the pre-Job meeting operations personnel make it dear that abrasive blasting will not permitted. The Owner’s representative asks you what other methods might be used. Of the options shown below, what would be the preferred option in this situation?

QUESTION 62
When working with someone who Is very concerned about stability and maintaining adherence to the status- quo, the Inspector should try to:

QUESTION 63
Differences in technique for abrasive blasting concrete versus steel require the operator to:

QUESTION 64
The most likely area of failure on a buried external pipeline coating is the:

QUESTION 65
A single component water borne acrylic coating cures by:

QUESTION 66
Surface preparation of concrete is performed using:

QUESTION 67
NACE No. 13/ SSPC 6 Identifies the use of:

QUESTION 68
The solvent sensitivity/solvent wipe test (ASTM D4752) is used to determine the cute of

QUESTION 69
Which is used to calibrate a pH meter?