PrepAwayPDF 300-815 Dumps Real Exam Questions Test Engine Dumps Training [Q19-Q33]

NEW QUESTION 19
A user’s phone is already configured for Single Number Reach, and the user wants a feature to move an active call from a mobile phone to a desk phone and vice-vers a. As an administrator, which additional configuration should be made to fulfill the user’s request?

NEW QUESTION 20
Refer to the exhibit.

An engineer is troubleshooting an issue where inbound calls to Cisco UCM with early media fail to establish. While investigating the issue, the engineer finds that Cisco UCM is set to require a PRACK. but the Cisco Unified Border Element is not sending it. Which command is causing this issue?

NEW QUESTION 21
Due to a shortage of physical interfaces on a device the administrator requires that a loopback for RTP is used.
Which command is required when using a loopback interface for RTP?

NEW QUESTION 22
When the services key is pressed Cisco Extension Mobility does not show up. What is the cause of the issue?

NEW QUESTION 23
An administrator is working on an issue between the customer s Cisco Unified Border Element and the service provider. The provider only wants to see mid-call signaling from the Cisco Unified Border Element for fax calls. Which command must be configured on Cisco Unified Border Element?

NEW QUESTION 24
An administrator sees the voice register pool 1 command in a Cisco UCME configuration. Which configuration is occurring in this section?

NEW QUESTION 25
After configuring a Cisco CallManager Express with Cisco Unity Express, inbound calls from the PSTN SIP trunk receive a ring tone for 20 seconds and then a busy signal instead of voicemail. Which configuration fixes this problem?

NEW QUESTION 26
Cisco SIP IP telephony is implemented on two floors of your company. Afterward, users report intermittent voice issues in calls established between floors. All calls are established, and sometimes they work well, but sometimes there is one-way audio or no audio. You determine that there is a firewall between the floors, and the administrator reports that it is allowing SIP signaling and UDP ports from 20000 to 22000 bidirectionally.
What are two possible solutions? (Choose two.)

NEW QUESTION 27
Refer to the exhibit. A standard local route group is configured for long-distance calls. Calls from building A succeed, but calls from building B fail. On the system. Each building has is own device pool. The DNA tool is used to test the configuration. How is this issue resolved?

NEW QUESTION 28
Which call pickup feature allows users to pick up incoming calls in a group that is associated with their own group?

NEW QUESTION 29
Which top-level IOS command is needed to begin the configuration of a Cisco Unified Communications Manager Express gateway to enable phones to be registered via SIP?

NEW QUESTION 30
The administrator of ABC company is troubleshooting a one-way audio issue for a call that uses
H.323protocol (slow-start mode). The administrator requests that you provide the IP and port information of the Real- Time Transport Protocol traffic that had the one-way audio call.
You gather the H.225 and H.245 messages for one of the one-way audio calls. Where can you find the RTP IP and port information for both sides? (Note: This call flow has not invoked any media resources like MTP or transcoders).

NEW QUESTION 31
Calls to a particular extension are not routing to voicemail. The user reaches the voicemail system from the handset by pressing the Messages button Which configuration parameter causes this problem?

NEW QUESTION 32
Refer to the exhibit.

In an active SIP call between phone user A and phone user B, phone A initiates a call transfer to phone user C.
Which two scenarios are correct? (Choose two.)

NEW QUESTION 33
Where on Cisco Unified Communications Manager do you configure the standard local route group for a group of devices?