Pass NACE NACE-CIP2-001 Exam With Practice Test Questions Dumps Bundle [Q52-Q68]

NO.52 You are working as the only in-house NACE Level 2 Inspector in a shop setting when an independent 3 rd party NACE Level 3 Inspector, representing the owner, presents you with a copy of a Non Conformance Report (NCR) he has written for a NACE2/SSPC SP 10 centrifugal blast which you had previously approved.
Your FIRST preferred course of action is to:

NO.53 Which standards are generally established by private-sector bodies and are available for use by any person or Organization, private or government?

NO.54 You have just your NACE CIP Level 2 certification when you are asked to supervise a team of uncertified field pipeline inspectors.
Your FIRST preferred course of action is to:

NO.55 You are working as an inspector in a galvanizing plant for the first time.
What are some of the hazards you need to be aware of:

NO.56 Cold-applied tape

NO.57 Linings are used on the interior of pipelines to

NO.58 Which surface preparation method uses a dilute acid solution to remove laitance and I roughen the concrete surface?

NO.59 It is always possible to see moisture on a steel substrate:

NO.60 When observing fabrication defects the NACE Inspector should:

NO.61 As a NACE Level 2 Inspector on a field job; prior to submission your documentation should always reviewed and approved by:

NO.62 NACE International Standards are developed by:

NO.63 You are the new NACE Level 2 Inspector on a job which had been very problematic. The previous Inspector was fired duo to personality conflicts with the Contractor’s supervisor. Upon arriving onsite the Contractor’s supervisor advises you in no uncertain terms that you will be the next to go, unless you cooperate with him.
Your FIRST preferred course of action is to:

NO.64 The standards defining surface cleanliness achieved by centrifugal blast cleaning are:

NO.65 You can use magnifiers to examine all of the following EXCEPT

NO.66 When NACE/SSPC WJ 1 is referenced; what type of equipment would the Inspector expect to see on the job:

NO.67 The most likely area of failure on a buried external pipeline coating is the:

NO.68 WJ-1 is always performed using UHWJ at pressures above 210 MPa (30,000 PSI)