[Q179-Q200] Use Real H12-931-ENU – 100% Cover Real Exam Questions [May-2022]

Rate this post

Use Real H12-931-ENU – 100% Cover Real Exam Questions [May-2022]

Dumps Brief Outline Of The H12-931-ENU Exam – PrepAwayPDF

NEW QUESTION 179
It is known that N*PTN sites are interconnected through WDM network. At this time, which of the following interface networking will not be used?

10GE

POS

Ch STM-1

ATM STM-1

NEW QUESTION 180
As shown in the figure, in the business configuration of the PP ring belt chain, discrete services are generated due to incomplete or incorrect configuration. In order to solve this discrete service, the service configuration needs to be supplemented. Which of the following steps are correct? (More select)

Create a two-way collusion service on U2000 for a single station of ADM2 site

Create a one-way collusion service on U2000 for a single station of ADM2 site

ADM3 site is not configured with optional receiving, you need to delete the working receiving and configure it again

ADM3 is not configured for optional reception, configure it directly on U2000

NEW QUESTION 181
Colorless & Directionless site configuration of a 100G coherent system, the line dimension adopts WSM9+RDU9, and the local drop configuration can adopt ()? (Multiple choice)

WSD9 drop directly

WSD9+OA+RDU9 drop

WSD9+TD20 drop

WSD9+OA+D40 drop

NEW QUESTION 182
Significance of engineering survey (multiple choices)

Confirm the design plan

Guide complete set stocking

Confirm the installation environment

Guide installation and implementation

NEW QUESTION 183
In the network management planning, which of the following descriptions is correct (multiple choice)

Equivalence factor = resources occupied by physical network elements or ports / system resources occupied by equivalent network elements; virtual network elements do not calculate management capabilities; pre-configured network elements are equivalent to virtual network elements.

Centralized deployment scheme is recommended for network management deployment planning. Only consider the use of a distributed deployment solution when the customer strongly requires it.

In the deployment planning of the network management subsystem, it is necessary to determine the network element manager subsystem to be installed according to the network element series. For example, if you need to use the Corba northbound interface, you need to install the Corba northbound subsystem.

Among other requirements, if the client is running on the server side at the same time, the management ability will be reduced by 60%, so it is recommended that the client and server be run separately.

NEW QUESTION 184
In a certain wavelength division system project, the 1st-20th wave LSX is configured, and the M40 output port is tested with a spectrum analyzer during commissioning. It is found that the optical power of the 20th wave is significantly lower than that of the other 19 waves. The possible reason is (multiple choice)

The 20th wave LSX WDM side light emission is too small

Wave 20 LSX wavelength shift

The insertion loss of the 20th channel corresponding to M40 is too large

The RX port of the 20th wave LSX has an additional 5dB fixed light attenuation

NEW QUESTION 185
In the ASON network, when a root optical fiber contains part of the multiplex section, the working time slot of the multiplex section constitutes (); the protection time slot of the multiplex section constitutes (), and the time slots unrelated to the multiplex section constitute (). If resources are reserved for the time slot (for static service use), this part of the time slot is divided into ().
Please select the answer that meets the requirements from the options below in order.

working link, protected link, unprotected link, static service dedicated link

Protected link, working link, unprotected link, unprotected link

working link, protection link, unprotected link, unprotected link

working link, protection link, unprotected link, protection link

NEW QUESTION 186
Which of the following statements about OTN overhead is correct? () (multiple choice)

5 consecutive frames in the SM/TCMi/PM overhead field (the 5th bit of the 3rd byte) The bit value of BDI is “1”, which will generate BDI

BIP-8 error codes in SM, PM, TCM monitor errors in different levels and areas in OTN

In the OTN frame structure, only SM overhead has IAE and BIAE functions

Both TCM and PM have ODUK-LCK, ODUK-OCI, ODUK-AIS three maintenance information

NEW QUESTION 187
The following is wrong about the position of the dispersion module in the signal flow.

If there is an OAU board, DCM is placed between OAU’s TDC/RDC

If there is only one OBU board, the DCM is placed after the OBU

If there are two OBU boards, the DCM is placed between the two OBUs

The OTM station usually pre-fills 20KM DCM before sending OBU

NEW QUESTION 188
The OSN8800 device newly expanded a TN55ND2 board, and it was found that the board could not go online. The following reasons are impossible:

SWDL_AUTOMATCH_INH alarm exists in the main control

SWDL_PKG_ NOBDSOFT alarm exists in the main control

SWDL_CHGMNG_NOMATCH alarm exists in the main control

SWDL_BD_WEAKMATCH alarm exists in the main control

NEW QUESTION 189
Preparation conditions for single-site commissioning of transmission equipment include (multiple choices)

Whether the hardware installation is qualified

Does the power supply have

Whether the related optical fiber and cable are installed in place

Make sure that the network management program installed on the laptop is normal

NEW QUESTION 190
The following clock networking optimizations are wrong:

Under the non-SSM switching protocol, the clock network can only be configured as one-way and cannot form a loop.

For PDH, ITU-T stipulates that 4 consecutive odd frames sa4~sa8 in 2M bit signal TS0 are used to transmit quality information, and SDH uses S1 byte b5-b8 to transmit the same quality information. SDH equipment can automatically extract SSM information from the 2Mhz external clock signal provided by the BITS equipment, so as to know the quality level of the timing signal.

Under the standard SSM switching protocol, the clock can be configured as bidirectional, but it must not be configured as a ring. Enable the extended SSM protocol to solve the clock loop problem by assigning a clock ID to the clock source.

Timing reference clock transmission link, requires that at most N=20 network elements, the transit office clock must be introduced for clock reshaping and regeneration (high-quality clocks are serialized), up to K=10 transit office clocks, clocks The maximum number of G.813 clocks on the link does not exceed 60.

NEW QUESTION 191
After the OTN device to the storage device is opened, the actual service rate is less than 20% of the interface rate. Possible reasons (multiple choice)

The FClicense configuration of the storage switch is incorrect

There is a problem with the docking optical power

Interface rate does not match

The remote function is not enabled on the docking port of the transmission device

NEW QUESTION 192
Drift refers to the long-term phase change of the digital signal relative to the standard signal less than 10 Hz, and jitter refers to the short-term phase change of the digital signal relative to the standard signal greater than 10 Hz.

TRUE

FALSE

NEW QUESTION 193
U2000-managed dual-machine software Veritas needs to apply for a license, one for the main and standby machines, and import them after activation. The licenses for the main and standby machines are different. For the U2000 license, you also need to activate it with their own ESNs and import them separately. The ESNs of the licenses of the active and standby machines are different.

TRUE

FALSE

NEW QUESTION 194
Optical wavelength sharing protection OWSP is used to configure a ring-type network of distributed services. By occupying two different wavelengths, it can protect all the distributed services between all sites and protect multiple services at the same time.

TRUE

FALSE

NEW QUESTION 195
Regarding the network element package loading package diffusion upgrade, which of the following statements is correct?

Configure activation grouping, gateway NEs and non-gateway NEs cannot be grouped into the same group

The number of network elements for the package diffusion upgrade task does not exceed 15.

The package diffusion software upgrade task may not include the gateway network element

The package diffusion software upgrade can only include at most one gateway network element, and the non-gateway network elements in the task must belong to the same gateway network element.

NEW QUESTION 196
During the equipment installation process, the following statement is wrong:

Wear anti-static gloves or anti-static wrist straps before touching the equipment, holding boards, veneers, IC chips, etc.

Inside the cabinet, the binding interval of optical fiber cable ties/optical fiber ties should not exceed 250mm, and the binding interval of user cable ties should not exceed 200mm

In order to dissipate heat, the empty slots on the network element can be used without filler panels

When plugging and unplugging a board with a connecting cable or pigtail on the panel, you should first unplug the connecting cable or pigtail before plugging and unplugging

NEW QUESTION 197
The sequence of downstream signals flowing through the functional blocks of the SL16 circuit board is

SPI, RST, MST, MSP, MSA, HPT

HPT, MSA, MSP, MST, RST, SPI

SPI, MST, RST, MSP, MSA, HPT

HPT, MSP, MSA, MST, RST, SPI

NEW QUESTION 198
When deploying QoS, where the complex classification of data flows is usually deployed in the network

Edge access layer

Convergence layer

Core layer

NEW QUESTION 199
What problems in the network cannot be solved by QoS?

Service bandwidth

Delay jitter in transmission

Packet loss rate

Transmission resource

NEW QUESTION 200
The following are the parts of the CORBA northbound interface and the corresponding functions of each part. Which is correct?

CORBA name service; provides the only entry for OSS to access the U2000 CORBA interface correctly.

CORBA name service; during deployment, it is necessary to ensure that the name of the managed U2000 is unique within the NMS management domain.

CORBA notification service; convert OSS request information into U2000 system internal interaction information, and receive alarms/performance/notifications.

CORBA notification service; when configuration data changes in U2000, OSS can be notified of detailed change information in time. Ensure the consistency of OSS and U2000 data

Certification Training for H12-931-ENU Exam Dumps Test Engine: https://www.prepawaypdf.com/Huawei/H12-931-ENU-practice-exam-dumps.html

[Q179-Q200] Use Real H12-931-ENU – 100% Cover Real Exam Questions [May-2022]

admin

Leave a Reply Cancel reply

Related posts:

admin

You might also like

Leave a Reply Cancel reply