[2023] Free JN0-663 Exam Dumps to Pass Exam Easily [Q44-Q67]

Rate this post

[2023] Free JN0-663 Exam Dumps to Pass Exam Easily

JN0-663 Exam Dumps, JN0-663 Practice Test Questions

NO.44 Exhibit:

R2 is receiving the same route from R1 and R3. You must ensure that you can load balance traffic for that route.
Referring to the exhibit, which two configuration changes will allow load balancing? (Choose two.)

Configure muitipath under group R1.

Configure muitipath under the global BGP configuration.

Apply the prepend policy as an import policy under group R3.

Apply the prepend policy as an import policy under group R1.

NO.45

Referring to the exhibit, there is a Layer 3 VPN setup that connects sites CE-A-1, CE-A-2, and CE-A-3 together. Host-1 can communicate with Host-3, but Host-1 cannot communicate with Host-2.
What must you do to solve the problem?

Change the route distinguisher in both routing instances to the same value.

Use the next-tableconfiguration statement for static routes in the corresponding routing instances.

Use BGP instead of static routing between the CE and PE devices.

Use the auto-exportcommand in both routing instances.

NO.46 You have a mixed vendor EVPN environment and you need to ensure VXLAN interoperability between all devices In this scenario which statement is correct?

You should only use Type 6 and Type 2 routes

You should only use pure Type 2 routes

You should only use Type 2 and Type 5 routes.

You should only use pure Type 5 routes

NO.47 You are deploying a new EVPN service for your customers.
You must build the service based on the following requirements:
– both Layer 2 and Layer 3 functionality must be supported;
– your customers must be able to support multiple VLANs in the same EVPN instance (EVI).
In this scenario, which two types of routing instances should be configured? (Choose two.)

virtual switch

virtual router

VRF

EVPN

NO.48 Exhibit:

Referring to the exhibit, which statement is true?

The route is learned from only one neighbor.

This is a multipath route.

The route is learned from three different neighbors.

This is a multihop route.

NO.49

Your router should be configured with a rewrite rule which alters the default behavior of expedited forwarding as shown in the exhibit.
In this scenario, which configuration is correct?

NO.50 Exhibit:

All networks shown in the exhibit contain more than one BGP speaker You operate ISP A and must ensure that Customer Y sends their traffic to you over the directly connected link. Customer Y is not to be used for transit into your network.
What would you do to accomplish this task?

Advertise routes to Customer Y with the custom defined 65535:65535 community.

Advertise routes to Customer Y with the well-known no-export community

Advertise routes to Customer X with the well-known no-advertise community.

Advertise routes to Customer X with the custom defined 0:0 community

NO.51 Exhibit:

R2 is receiving the same route from R1 and R3. You must ensure that you can load balance traffic for that route.
Referring to the exhibit, which two configuration changes will allow load balancing? (Choose two.)

Configure muitipath under group R1.

Configure muitipath under the global BGP configuration.

Apply the prepend policy as an import policy under group R3.

Apply the prepend policy as an import policy under group R1.

NO.52 Exhibit.

You are provisioning Layer 2 circuits between sites CE1. CE2. andCE3
Referring to the exhibit, which statement is true?

Two VLANs must be configured from PE1 to CE1.

A point-to-multipoint LSP must be created between sites.

Site PE1 must have a point-to-multipoint link configured towards the core

Each site must have only one VLAN configured to the PE

NO.53 Exhibit:

Referring to the exhibit, which two statements are correct? (Choose two.)

R1 will never forward transit traffic through R2.

Transit traffic from R1 to R4 will traverse R3.

The OSPF interface metrics on R2 are all set to 65535.

R2 stops sending LSAs into the network.

NO.54

Traffic is being sent from R2 to R3. The link between R2 and R3 fails.
Referring to the exhibit, which statement is correct?

Traffic will automatically reroute using the shortest path, which is R2 to R1 to R3.

Traffic will automatically reroute distributed between all available paths.

Manual intervention is required for traffic to be rerouted.

Traffic will automatically reroute using R2 to R4 to R1 to R3.

NO.55 Exhibit:

Referring to the exhibit, the local BGP router is receiving IPv4 routes from the BGP neighbor, but it is not receiving L3 VPN routes from the BGP neighbor.
Which two actions should you take to solve this problem? (Choose two.)

Configure the family inet-vpn unicast statement on the local BGP router.

Configure the family inet unicast statement on the local BGP router.

Configure the family inet unicast statement on the BGP neighbor

Configure the family inet-vpn unicast statement on the BGP neighbor.

NO.56 Exhibit.

Referring to the exhibit, which statement is true?

The BGP session between R1 and R2 will fail to establish correctly due to an NLRI mismatch

The BGP session between R1 and R2 will establish correctly and the met unicast and the met6 unicast NLRIs will pass routing information

The BGP session between R1 and R2 will establish correctly and only the inet6 unicast NLRI will pass routing information

The BGP session between R1 and R2 will establish correctly and only the met unicast NLRI will pass routing information

NO.57 Which two statements about IS-IS are correct? (Choose two.)

Level 1 intermediate systems exchange routing information with Level 1 intermediate systems in other IS-IS areas.

An IS-IS router sets the attached bit in the PDUs it sends to a Level 1 area to indicate that it is a backbone router.

A Level 1 router can only form adjacencies with other Level 1 routers.

Level 2 routers can form adjacencies with either Level 1 or Level 2 routers.

NO.58 Exhibit.

Your router should be configured with a rewrite rule which alters the default behavior of expedited forwarding as shown in the exhibit In this scenario which configuration is correct?
A)

B)

C)

D)

Option A

Option B

Option C

Option D

NO.59 Which two statements are true about what a route reflector does by default when distributing routes it has received from reflector clients? (Choose two.)

It changes the default BGP attributes to inform peers that it is a route reflector.

It adds its cluster ID to the client-received routes.

It sets the next hop of all routes to “self’ to prevent routing loops.

It does not change any received BGP attributes.

NO.60 Exhibit.

Referring to the exhibit, which two statements are correct for a route advertised by R1 towards R4? (Choose two )

The BGP next hop is set to 14.1.1.1 by R2.

The AS path is set to 150 by R2.

The BGP next hop is set to 192.168.2.2 by R2.

The AS path is set to null by R2.

NO.61 Exhibit:

You must configure an OSPF virtual link to facilitate communication between Area 0 and Area 20.
Referring to the exhibit, which two addresses should you use as the neighbor IDs of the virtual link endpoints? (Choose two.)

The address that is associated with R2’s router ID.

The address that is associated with R4’s router ID.

The address that is associated with R2’s xe-1/2/0 interface.

The address that is associated with R4’s xe-0/0/1 interface.

NO.62 Exhibit.

R2 has IS-IS adjacencies with R3 and R4 You want to ensure that R2 has both a level 1 and level 2 adjacency to both R3 and R4 but R2 only has one adjacency with R4.
Referring to the exhibit, which configuration change will solve this issue?

Change the IS-IS area on R2 to match R4.

Change the IS-IS area on R4 to match R2

Remove the level 1 disable configuration from R4

Remove the level 1 disable configuration from R2

NO.63 Exhibit:

Which three statements are true about the show pim join output shown in the exhibit? (Choose three.)

This is a source-specific multicast stream.

The multicast receiver is still using the RP to receive the stream.

The multicast stream has been configured with a backup path to allow for fast reroute.

The multicast stream does not have an RP.

The shortest path to the source is through the RP.

NO.64 Exhibit:

Referring to the exhibit, which two statements are true? (Choose two.)

This router is an ABR

This router is an ASBR.

There are two interfaces marked as passive.

There is one interface marked as passive.

NO.65 Exhibit:

All adjacencies have been formed, no extra options have been configured, and no policies have been written.
Referring to the exhibit, which two statements are correct? (Choose two.)

R1 cannot reach R5

R1 will create its own default route that points to R2

R2 will create a default route and send it as a TLV to R1

R1 can reach R5.

NO.66 Exhibit:

Referring to the exhibit, which two statements are true? (Choose two.)

This router is an ABR

This router is an ASBR.

There are two interfaces marked as passive.

There is one interface marked as passive.

NO.67 Exhibit:

A network administrator is concerned about the number of LSAs that they are observing on the network.
What will reduce Type 7 LSAs advertised from R2 to the non-backbone routers shown in the exhibit?