Updated Aug-2024 NSE7_SDW-7.2 Free Exam Files Downloaded Instantly [Q48-Q63]

Rate this post

Updated Aug-2024 NSE7_SDW-7.2 Free Exam Files Downloaded Instantly

Practice Exams and Training Solutions for Certifications

NEW QUESTION 48
The administrator uses the FortiManager SD-WAN overlay template to prepare an SD-WAN deployment. With information provided through the SD-WAN overlay template wizard, FortiManager creates templates ready to install on spoke and hub devices.
Select three templates created by the SD-WAN overlay template for a spoke device. (Choose three.)

System template

BGP template

dIPsec tunnel template

CLI template

Overlay template

NEW QUESTION 49
Refer to the exhibit.

Which statement explains the output shown in the exhibit?

FortiGate performed standard FIB routing on the session.

FortiGate will not re-evaluate the session following a firewall policy change.

FortiGate used 192.2.0.1 as the gateway for the original direction of the traffic.

FortiGate must re-evaluate the session due to routing change.

NEW QUESTION 50
Which two statements describe how IPsec phase 1 main mode is different from aggressive mode when performing IKE negotiation? (Choose two )

A peer ID is included in the first packet from the initiator, along with suggested security policies.

XAuth is enabled as an additional level of authentication, which requires a username and password.

A total of six packets are exchanged between an initiator and a responder instead of three packets.

The use of Diffie Hellman keys is limited by the responder and needs initiator acceptance.

NEW QUESTION 51
Refer to the exhibit.

Which are two expected behaviors of the traffic that matches the traffic shaper? (Choose two.)

The number of simultaneous connections among all source IP addresses cannot exceed five connections.

The traffic shaper limits the combined bandwidth of all connections to a maximum of 5 MB/sec.

The number of simultaneous connections allowed for each source IP address cannot exceed five connections.

The traffic shaper limits the bandwidth of each source IP address to a maximum of 625 KB/sec.

NEW QUESTION 52
What is a benefit of using application steering in SD-WAN?

The traffic always skips the regular policy routes.

You steer traffic based on the detected application.

You do not need to enable SSL inspection.

You do not need to configure firewall policies that accept the SD-WAN traffic.

NEW QUESTION 53
Which SD-WAN setting enables FortiGate to delay the recovery of ADVPN shortcuts?

hold-down-time

link-down-failover

auto-discovery-shortcuts

idle-timeout

NEW QUESTION 54
Refer to the exhibit.

In a dual-hub hub-and-spoke SD-WAN deployment, which is a benefit of disabling the anti-replay setting on the hubs?

It instructs the hub to disable the reordering of TCP packets on behalf of the receiver, to improve performance.

It instructs the hub to disable TCP sequence number check, which is required for TCP sessions originated from spokes to fail over back and forth between the hubs.

It instructs the hub to not check the ESP sequence numbers on IPsec traffic, to improve performance.

It instructs the hub to skip content inspection on TCP traffic, to improve performance.

NEW QUESTION 55
Refer to the exhibit.

The device exchanges routes using IBGP.
Which two statements are correct about the IBGP configuration and routing information on the device?
(Choose two.)

Each BGP route is three hops away from the destination.

ibgp-multipath is disabled.

additional-path is enabled.

You can run the get router info routing-table database command to display the additional paths.

NEW QUESTION 56
What are two advantages of using an IPsec recommended template to configure an IPsec tunnel in a hub-and-spoke topology? (Choose two.)

VPN monitor tool provides additional statistics for tunnels defined with an IPsec recommended template.

FortiManager automatically installs IPsec tunnels to every spoke when they are added to the FortiManager ADOM.

IPsec recommended template guides the administrator to use Fortinet recommended settings.

IPsec recommended template ensures consistent settings between phase1 and phase2

NEW QUESTION 57
Refer to the exhibits.

An administrator is testing application steering in SD-WAN. Before generating test traffic, the administrator collected the information shown in exhibit A.
After generating GoToMeeting test traffic, the administrator examined the respective traffic log on FortiAnalyzer, which is shown in exhibit B. The administrator noticed that the traffic matched the implicit SD-WAN rule, but they expected the traffic to match rule ID 1.
Which two reasons explain why the traffic matched the implicit SD-WAN rule? (Choose two.)

FortiGate did not refresh the routing information on the session after the application was detected.

Port1 and port2 do not have a valid route to the destination.

Full SSL inspection is not enabled on the matching firewall policy.

The session 3-tuple did not match any of the existing entries in the ISDB application cache.

NEW QUESTION 58
Exhibit.

The exhibit shows the output of the command diagnose sys sdwan health-check status collected on a FortiGate device. Which two statements are correct about the health check status on this FortiGate device? (Choose two.)

The health-check VPN_PING orders the members according to the lowest jitter.

The interface T_INET_1 missed one SLA target.

There is no SLA criteria configured for the health-check Level3_DNS.

The interface T_INET_0 missed three SLA targets.

NEW QUESTION 59
Refer to the exhibit.

Based on the exhibit, which two statements are correct about the health of the selected members? (Choose two.)

After FortiGate switches to active mode, FortiGate never fails back to passive monitoring.

During passive monitoring, FortiGate can’t detect dead members.

FortiGate can offload the traffic that is subject to passive monitoring to hardware.

FortiGate passively monitors the member if TCP traffic is passing through the member.

NEW QUESTION 60
Exhibit.

Which conclusion about the packet debug flow output is correct?

The total number of daily sessions for 10.1.10.1 exceeded the maximum number of concurrent sessions configured in the traffic shaper, and the packet was dropped.

The packet size exceeded the outgoing interface MTU.

The number of concurrent sessions for 10.1.10.1 exceeded the maximum number of concurrent sessions configured in the traffic shaper, and the packet was dropped.

The number of concurrent sessions for 10.1.10.1 exceeded the maximum number of concurrent sessions configured in the firewall policy, and the packet was dropped.

NEW QUESTION 61
Refer to the exhibit.

Which statement about the role of the ADVPN device in handling traffic is true?

This is a spoke that has received a query from a remote hub and has forwarded the response to its hub.

Two hubs, 10.0.1.101 and 10.0.2.101, are receiving and forwarding queries between each other.

This is a hub that has received a query from a spoke and has forwarded it to another spoke.

Two spokes, 192.2.0.1 and 10.0.2.101, forward their queries to their hubs.

NEW QUESTION 62
In the default SD-WAN minimum configuration, which two statements are correct when traffic matches the default implicit SD-WAN rule? (Choose two )

Traffic has matched none of the FortiGate policy routes.

Matched traffic failed RPF and was caught by the rule.

The FIB lookup resolved interface was the SD-WAN interface.

An absolute SD-WAN rule was defined and matched traffic.

NEW QUESTION 63
Which best describes the SD-WAN traffic shaping mode that bases itself on a percentage of available bandwidth?

Interface-based shaping mode

Reverse-policy shaping mode

Shared-policy shaping mode

Per-IP shaping mode

Q&As with Explanations Verified & Correct Answers: https://www.prepawaypdf.com/Fortinet/NSE7_SDW-7.2-practice-exam-dumps.html

Related posts:

admin

You might also like

Leave a Reply Cancel reply