Oct-2024 Realistic CQE Exam Dumps with Accurate & Updated Questions [Q60-Q84]

NO.60 If a distribution is skewed to the right

NO.61 The holes in this drawing have what kind of tolerance?

The holes in this drawing have what kind of tolerance?

NO.62 What type of audit should be used to determine how well an organization’s activities conform to its quality program?

NO.63 Typically Pareto diagrams are used for which of the following reasons?
I. To display the significant few categories.
II. To compliment attribute data charting.
III. To eliminate insignificant categories.
IV. To focus attention in priority order.

NO.64 A graph of a data set, composed of a series of rectangles, each proportional in width to the range of values in a class and proportional in height to the number of items or fraction of items falling in these classes, is called which of the following?

NO.65 The example of a supplier’s quality management effort to meet your existing contractual requirements is MOST like
I. A product audit.
II. A process audit.
III. A system audit.

NO.66 The design function which assigns probability of failures between components or subsystems is called

NO.67 Which of the following nondestructive testing methods can be used to evaluate sub-surface discontinuities in aluminum bar stock?
I. Microwave.
II. Magnetic particle.
III. Pulse echo.
IV. Eddy current.

NO.68 A bin contains 40 pills with a weight of 3.1 gm. each, 30 pills weighing 3.2 gms each and 10 pills weighing 3.3 gms each. The weight of an average pill is found from

NO.69 The ideal results of a quality training effort would NOT include which of the following?

NO.70 Which of the following statements BEST describes a bimodal distribution?

NO.71 An electronics firm was experiencing high rejections in their multiple connector manufacturing departments. “p” charts were introduced as part of a program to reduce defectives. Control limits were based on prior history, using the formula:

P’ is the historical value of percent defective and n is the number of pieces inspected each week. After six weeks, the following record was accumulated

1,000 pieces were inspected each week in each department. Which department(s) exhibited a point or points out of control during this period (round off calculations to nearest tenth of a percentage point)?

NO.72 The primary reason that nonconforming material should be identified and segregated is

NO.73 A three-level, two-variable, full factorial experiment is to be run. The minimum number of runs will be

NO.74 An experiment with two factors, in which all levels of one variable are run at each level of the second variable, is called a

NO.75 The AQL for a given sampling plan is 1% this means that

NO.76 In order to implement a continuous improvement strategy, a company may institute a steering committee or improvement council. Which of the following would generally NOT be a task performed by this council?

NO.77 When nonconforming items are found, which of the following actions should be taken first?

NO.78 If the probability of a success on a single trial is 0.2 and 3 trials are performed, what is the probability of at least one success?

NO.79 The equation below represents the:

NO.80 Failure mode, effect, and criticality analysis, (FMECA) is primarily for the purpose of

NO.81 A customer rates its suppliers for which of the following reasons?

NO.82 A company’s quality policy should be developed by the

NO.83 Which of the following parties, traditionally initiates an audit?

NO.84 In most cases, an improvement team facilitator will NOT normally: