[Sep 12, 2026] Uplift Your HPE6-A86 Exam Marks With The Help of HPE6-A86 Dumps [Q26-Q44]

Q26. Which attributes are true about UDP? (Choose two.)

Q27. A customer with stacked switches needs PoE+ ports featured with near-zero downtime, continuous packet forwarding, and highly available hardware.
Which is correct for an HPE Aruba Networking CX solution?

Q28. Which CX model allows for VSF?

Q29. Which phase of OSPF involves running the SPF algorithm to determine the best path for each network destination?

Q30. What is modulated to transmit data over a multi-mode cable?

Q31. A Network Operator must configure a static route for a specific partner network (172.25.0.0/16) that is reachable via a router at 10.100.254.254.
What are the essential components of a static route configuration? (Select all that apply.)

Q32. A four-member HPE Aruba Networking CX 6200F VSF configuration is planned to replace the current
5412R switch. The customer has an open-source network management solution.
How should you respond to their question about monitoring the switches securely?

Q33. A Network Operator is configuring QoS on an HPE Aruba Networking CX switch. The operator needs to classify traffic based on the application being used, such as distinguishing between HTTP and FTP traffic.
Which of the following is used to identify the application at Layer 4 for QoS classification?

Q34. Your colleague is installing a new HPE Aruba Networking CX 8100 switch in a data center in the default configuration. You monitor the peer switch port 1/1/1 status, connected with a 10Gb 3m DAC cable to the new switch, and validate that the cable is attached. The port remains down.
What should you suggest your colleague do so the port can come online?

Q35. You are planning a 40Gbps link between two sites 35km apart. What type of cable will be required?

Q36. A junior network engineer is configuring a Network Management System (NMS) to monitor the health and performance of all switches on the network. The NMS needs to periodically poll the switches for information like interface status, CPU utilization, and memory usage. Which protocol and which action is used for this purpose? (Choose 2.)

Q37. A router’s IP routing table has an entry with a next-hop IP address of 10.30.233.1.
What does this number represent?

Q38. Identify the type of fiber optic connector type shown below:

Q39. Which firewall port needs to be opened between your HPE Aruba Networking CX switches and the Network Monitoring System to send monitoring alerts using SNMP?

Q40. What are the three basic objectives of network security? (Select three)

Q41. A junior network engineer is troubleshooting why a PC with IP address 192.168.1.50 cannot communicate with its default gateway at 192.168.1.254. The engineer checks the ARP table on the default gateway (an AOS-CX switch).
Review the ARP table output from the switch:
show arp
IP Address MAC Address Port Type
–
192.168.1.10 00:50:56:a1:b2:c3 1/1/5 Dynamic
192.168.1.50 Incomplete 1/1/10 Dynamic
Based on the output, what is the most likely problem? (Choose 2.)

Q42. Which statement about in-band management is true?

Q43. A Junior Network Engineer is comparing FTP and SFTP for managing switch configurations.
What are the key differences between FTP and SFTP? (Select all that apply.)

Q44. A Network Technician is troubleshooting an intermittent connectivity issue on a copper link. The technician suspects the problem might be related to the cable itself. Which of the following represents a physical (Layer 1) problem?