[Q17-Q37] Verified NSE7_SDW-6.4 dumps Q&As – Pass Guarantee Exam Dumps Test Engine [2022]

Rate this post

Verified NSE7_SDW-6.4 dumps Q&As – Pass Guarantee Exam Dumps Test Engine [2022]

NSE7_SDW-6.4 dumps and 37 unique questions

NEW QUESTION 17
Which statement defines how a per-IP traffic shaper of 10 Mbps is applied to the entire network?

FortiGate allocates each IP address a maximum 10 Mbps of bandwidth.

Each IP is guaranteed a minimum 10 Mbps of bandwidth

A single user uses the allocated bandwidth divided by total number of users.

The 10 Mbps bandwidth is shared equally among the IP addresses.

NEW QUESTION 18
Refer to the exhibit.

Which two statements about the status of the VPN tunnel are true? <Choose two )

There are separate virtual interfaces for each dial-up client.

VPN static routes are prevented from populating the FortiGate routing table.

FortiGate created a single IPsec virtual interface that is shared by all clients.

100.64.3.1 is one of the remote IP address that comes through index interface 1.

NEW QUESTION 19
Refer to exhibits.
Exhibit A.

Exhibit B.

Exhibit A shows the traffic shaping policy and exhibit B show: the firewall policy FortiGate is not performing traffic shaping as expected basi on the policies shown in the exhibits.
To correct this traffic shaping issue on FortiGate, what configuration change must be made on which policy?

The shaper mode must be applied per-IP shaper on the traffic shaping policy

The application control profile must be enabled on the firewall policy.

The web filter profile must be enabled on the firewall policy

The URL category must be specified on the traffic shaping policy

NEW QUESTION 20
Refer to exhibits.

Exhibit A shows the source NAT global setting and exhibit B shows the routing table on FortiGate.
Based on the exhibits, which two statements about increasing the port2 interface priority to 20 are true? (Choose two.)

All the existing sessions that do not use SNAT will be flushed and routed through port1.

All the existing sessions will continue to use port2, and new sessions will use port1.

All the existing sessions using SNAT will be flushed and routed through port1.

All the existing sessions will be blocked from using port1 and port2.

NEW QUESTION 21
Refer to the exhibit.

Based on the exhibit, which statement about FortiGate re-evaluating traffic is true?

The type of traffic defined and allowed on firewall policy ID 1 is UDP.

FortiGate has terminated the session after a change on policy ID 1.

Changes have been made on firewall policy ID 1 on FortiGate.

Firewall policy ID 1 has source NAT disabled.

NEW QUESTION 22
Which diagnostic command you can use to show interface-specific SLA logs for the last 10 minutes?

diagnose sys virtual-wan-link health-check

diagnose sys virtual-wan-link log

diagnose sys virtual-wan-link sla-lcg

diagnose sys virtual-wan-link intf-sla-log

NEW QUESTION 23
Which components make up the secure SD-WAN solution?

Application, antivirus, and URL, and SSL inspection

Datacenter, branch offices, and public cloud

FortiGate, FortiManager, FortiAnalyzer, and FortiDeploy

Telephone, ISDN, and telecom network.

NEW QUESTION 24
What are two roles that SD-WAN orchestrator plays when it works with FortiManager? (Choose two.)

It configures and monitors SD-WAN networks on FortiGate devices that are managed by FortiManager.

It acts as a standalone device to assist FortiManager to manage SD-WAN interfaces on the managed FortiGate devices.

It acts as a hub FortiGate with an SD-WAN interface enabled and managed along with other FortiGate devices by FortiManager.

It acts as an application that is released and signed by Fortinet to run as a part of management extensions on FortiManager.

NEW QUESTION 25
Refer to the exhibit.

FortiGate has multiple dial-up VPN interfaces incoming on port1 that match only FIRST_VPN.
Which two configuration changes must be made to both IPsec VPN interfaces to allow incoming connections to match all possible IPsec dial-up interfaces? (Choose two.)

Specify a unique peer ID for each dial-up VPN interface.

Use different proposals are used between the interfaces.

Configure the IKE mode to be aggressive mode.

Use unique Diffie Hellman groups on each VPN interface.

NEW QUESTION 26
Refer to the exhibit.

Which statement about the command route-tag in the SD-WAN rule is true?

It enables the SD-WAN rule to load balance and assign traffic with a route tag

It tags each route and references the tag in the routing table.

It uses route tags for a BGP community and assigns the SD-WAN rules with same tag.

It ensures route tags match the SD-WAN rule based on the rule order

NEW QUESTION 27
Refer to the exhibit.

What must you configure to enable ADVPN?

On the hub VPN, only the device needs additional phase one sett

ADVPN should only be enabled on unmanaged FortiGate devices.

Each VPN device has a unique pre-shared key configured separately on phase one

The protected subnets should be set to address object to all (0.0 .0. o/o).

NEW QUESTION 28
Refer to the exhibit.

What must you configure to enable ADVPN?

On the hub VPN, only the device needs additional phase one sett

ADVPN should only be enabled on unmanaged FortiGate devices.

Each VPN device has a unique pre-shared key configured separately on phase one

The protected subnets should be set to address object to all (0.0 .0. o/o).

NEW QUESTION 29
Refer to the exhibit.

Based on the output shown in the exhibit, which two criteria on the SD-WAN member configuration can be used to select an outgoing interface in an SD-WAN rule? (Choose two.)

Set priority 10.

Set cost 15.

Set load-balance-mode source-ip-ip-based.

Set source 100.64.1.1.

NEW QUESTION 30
Which diagnostic command can you use to show the SD-WAN rules interface information and state?

diagnose sys virtual-wan-link neighbor.

diagnose sys virtual-wan-link route-tag-list

diagnose sys virtual-wan-link member.

diagnose sys virtual-wan-link service

NEW QUESTION 31
Refer to the exhibit.
Multiple IPsec VPNs are formed between two hub-and-spokes groups, and site-to-site between Hub 1 and Hub 2 The administrator configured ADVPN on the dual regions topology

Which two statements are correct if a user in Toronto sends traffic to London? (Choose two )

Toronto needs to establish a site-to-site tunnel with Hub 2 to bypass Hub 1.

The first packets from Toronto to London are routed through Hub 1 then to Hub 2.

Traffic from Toronto to London triggers the dynamic negotiation of a direct site-to-site VPN

London generates an IKE information message that contains the Toronto public IP address

NEW QUESTION 32
What are two benefits of using FortiManager to organize and manage the network for a group of FortiGate devices? (Choose two )

It simplifies the deployment and administration of SD-WAN on managed FortiGate devices.

It improves SD-WAN performance on the managed FortiGate devices.

It sends probe signals as health checks to the beacon servers on behalf of FortiGate.

It acts as a policy compliance entity to review all managed FortiGate devices.

It reduces WAN usage on FortiGate devices by acting as a local FortiGuard server.

NEW QUESTION 33
What are the two minimum configuration requirements for an outgoing interface to be selected once the SD-WAN logical interface is enabled? (Choose two )

Specify incoming interfaces in SD-WAN rules.

Specify outgoing interface routing cost.

Configure SD-WAN rules interface preference.

Select SD-WAN balancing strategy.

NEW QUESTION 34
Refer to the exhibit.

Based on the exhibit, which statement about FortiGate re-evaluating traffic is true?

The type of traffic defined and allowed on firewall policy ID 1 is UDP.

FortiGate has terminated the session after a change on policy ID 1.

Changes have been made on firewall policy ID 1 on FortiGate.

Firewall policy ID 1 has source NAT disabled.

NEW QUESTION 35
An administrator is troubleshooting VoIP quality issues that occur when calling external phone numbers The SD-WAN interface on the edge FortiGate is configured with the default settings, and is using two upstream links One link has random jitter and latency issues and is based on a wireless connection Which two actions must the administrator apply simultaneously on the edge FortiGate to improve VoIP quality using SD_WAN rules?

Select the corresponding SD-WAN balancing strategy in the SD-WAN rule.

Choose the suitable interface based on the interface cost and weight.

Use the performance SLA targets to detect latency and jitter instantly.

Place the troublesome link at the top of the interface preference list.

Configure an SD-WAN rule to load balance all traffic without VoIP.

NEW QUESTION 36
Refer to the exhibit.

Which statement about the trace evaluation by FomGate is true?

The packet exceeded the configured maximum bandwidth and was dropped by the shared shaper.

Packets exceeding the configured maximum concurrent connection limit are denied by the per-IP shaper.

Packets exceeding the configured concurrent connection limit are dropped based on tfte priority configuration.

The packet exceeded the configured bandwidth and was dropped based on the priority configuration

NEW QUESTION 37
Refer to exhibits.
Exhibit A.

Exhibit B.

Exhibit A, which shows the SD-WAN performance SLA and exhibit B shows the health of the participating SD-WAN members.
Based on the exhibits, which statement is correct?

The dead member interface stays unavailable until an administrator manually brings the interface back.

The SLA state of port2 has exceeded three consecutive unanswered requests from the SLA server.

Port2 needs to wait 500 milliseconds to change the status from alive to dead.

Check interval is the time to wait before a packet sent by a member interface considered as lost.

Fortinet NSE7_SDW-6.4 Exam Syllabus Topics:

Topic	Details
Topic 1	Central management Configure SD-WAN SLAs
Topic 2	Centrally manage an SD-WAN infrastructure from FortiManager Configure basic SD-WAN setup
Topic 3	Configure SD-WAN routing SD-WAN troubleshooting

NSE7_SDW-6.4 Dumps for Pass Guaranteed – Pass NSE7_SDW-6.4 Exam: https://www.prepawaypdf.com/Fortinet/NSE7_SDW-6.4-practice-exam-dumps.html

Fortinet NSE7_SDW-6.4 Exam Syllabus Topics:

Related posts:

admin

You might also like

Leave a Reply Cancel reply